parts

make-ready knuckles

P/N: 20000405 accepts ½-inch rod clearance holes in both halves
P/N: 20000407 accepts ½-inch rod one clearance hole, one tapped hole
P/N: 20001467-WS accepts two ½-inch rods rods are contained between clamp half and spacing washer
P/N: 206555 accepts two 5/8-inch rods rods are contained between clamp half and internal clamp spacer
P/N: W911199 accepts two ½-inch rods no tools required clamp is adjusted by means of a thumb screw

WSI manufactures and assembles all parts and equipment in the USA